1. Using your computer, design and create your own custom decal.

2.  Set your printer's resolution to "Highest" or "Best" and choose "Photo or "Gloss" for your paper option (you will be printing on the "glossy" side of the decal paper).  For best results feed your printer one sheet at a time to avoid jamming.

3.  After printing your decal on inkjet printer paper, allow the ink to dry for 30 minutes.  Then use Krylon's® Acrylic Crystal Clear High Gloss Spray or any acrylic clear gloss spray available from your local Hardware Store, and apply an even shine on the sheet.  Allow 45 - 60 minutes drying time.  Note:  The laser printer paper does not require application of the spray.  After the ink has been allowed sufficient time to dry, go to Step 4.

4. Using a pair of sharp scissors, carefully cut as close as possible around the decal and remove it from the sheet.  Immerse the decal in a bowl of water for approximately 30 seconds and remove once you feel the decal starts to slide off  the white paper backing.  Your decal is now ready to be applied. 

5.  Please make sure all surfaces are clean before applying the decal. Carefully place and position the decal on the object.  Gently remove the backing paper and hold in position for approximately 30 seconds while the decal sets.  Add water to the surface as needed if it requires moving.  Then gently pat the decal dry and remove any air bubbles with an absorbent paper towel.  After drying overnight, your decorated object is ready.  If you prefer, you may seal the decal with a clear gloss spray finish after it has dried overnight.